Bondwell 14 and 16

[LS120]

the switch should look like the pic below now..

[LS120]

now gently pull out the inner switch from other side the whole thing should come out..

[LS120]

noe gently take the metal switch clip off dont worry if you have to bend a little to get off we will have to re-bend to make tighter as that is part of problem..

[LS120]

ok so testing switch gave open switch and pressing center button did nothing o used some contact cleaner to clean any oxidization in side the 2 metal plates..

[LS120]

ok so after cleaning the switch seem fine now..

[LS120]

ok so now to re-assemble the switch.. this is not hard but can be a little tricky..

put the white plastic plunger in the top of the switch case (it will only go in one way)

[LS120]

slide in in the right set of guides and slide in right down..

[LS120]

plunger all the way down..

[LS120]

now look close you can see the 2nd set of slots for the switch put switch the right way around

[LS120]

the metal part that pushes the switch closed should be against the white plunger..

[LS120]

pus the switch down and make sure its right down.. don't be to rough,, now with the switch in place use your jewelers screw drive to bend the metal pusher legs for the switch out a little this makes the plunger press harder on the switch.

[LS120]

next place the spring on the little tit inside in the plunger.. holding it all upright..

[LS120]

now gently position the base in the switch and make sure you have the switch legs and spring in the right places..

[LS120]

now gently press the 2 parts together.. and Click its closed..

[LS120]

now test the switch and it should work as new.. i did test the switch when re assembling but you only need to do it before the spring and bottom clips on..