Switch to full style

Eprom Programming available

Seek advice, give advice or tell others about your repair and restoration projects

Eprom Programming available

by Mark0x01 » Wed Jun 06, 2018 9:26 pm

If anyone in the Auckland area needs eproms programmed, I am happy to help out, having just added a Willem Programmer to my toolbox.

An upgrade on my ancient PCP-128 ISA bus Prom Blaster of 1985 vintage.

With no shortage of devices with parallel ports, and a need to cover back to 2716's and 25v vpp and a budget means vintage design rules.

I have just tried it out on a 2732A with immediate success.

Posts: 32
Joined: Sun Jun 23, 2013 2:11 pm

Re: Eprom Programming available

by tezza » Wed Jun 06, 2018 10:05 pm

Good to know Mark,

Tez (Terry Stewart) (Administrator)
Collection: https://www.classic-computers.org.nz/co ... /index.htm
Projects and Articles: https://www.classic-computers.org.nz/blog/index.htm
Twitter: @classiccomputNZ | YouTube: Terry Stewart
Trade Me: tezza5
Site Admin
Posts: 2380
Joined: Thu Jan 01, 1970 12:00 pm
Location: Palmerston North, New Zealand

Re: Eprom Programming available

by LS120 » Sun Jul 15, 2018 10:00 pm

what model did you get?

as they have a few different ones..
Posts: 491
Joined: Fri Jul 22, 2016 9:19 pm
Location: Wellington

Re: Eprom Programming available

by Mark0x01 » Fri Jul 20, 2018 7:35 pm

Supposedly PCB5 OE 2018 - the parallel port version.

It seems to be one of the better ones, and I have tested the VPP power with a resistor as load to check for sag.

And it was within budget :D

I also splashed out on an M328 LCR, Diode, Capacitance, ESR & Transistor Tester kit.

I'm upgrading it to 0.1% resistors, as suggested on a few forums. It seems to work quite well.
Posts: 32
Joined: Sun Jun 23, 2013 2:11 pm

Who is online

Users browsing this forum: No registered users and 2 guests